I lost my Lucidity cup with leather holster and clip. If you found it and could return it, I would appreciate it.

Sorry for all the questions and thank you for your patience. I thought this was going to go much smoother, but I bought the wrong pump twice ; ). I currently have a 100w Solar Panel, two 35amp Deep Cycle Batteries, two small wind generators and an inverter. Rather than returning this second 7volt so...

The picture on the first page of this forum ; ). I'll look into these two. Thank you!

1. So, I got the new solar pump in and there are two wires: red and blue. The rep at SilverStone informed me the the fan wires are: Red (power), Black (ground) and yellow is for the RPMs, so I splice red to red and black to blue? 2. My fan, while it is the SST-AP181 12v .45amp, it is .7' in diameter...

Dang it. Yup it's AC, I went back and found the one you mentioned at the beginning of the thread. Round 2

Hello! I just started building my swamp cooler and bought the Silver Stone SST-AP181, which is almost 7" in diameter...crazy. Anyway, I mounted the fan to the 5gal bucket, but now need to splice the water pump to the fan and am not clear on the process. The water pump has black, white and green wire...

maladroit wrote:
"you'll want to explore and help others. You only have one first year.

" Yes and yes!!! I'm excited for ALL of it .

Maladroit,

I am taking your advice. It will take much less time and simpler resources to construct a Monkey Hut. Thank you again!

Thank you Maladroit for your detailed feedback, especially the part about being more isolated as to open. I will certainly consider them in my final decision.

Here it is with Dimensions.

Aloha, Yes, even if I remove the tent itself (still undecided), the canopy remains, which is also the lid/cover to the trailer and has my bike/surf racks for transport. With the tent removed, the lid can be dropped to a lower position, but not to the point where it would fit in the Yurt efficiently....

So I measured the Tent Trailer and it come out to 19.1'Lx7.57'Wx8.4'T. I am not considering and attempting to design 24'x24' to encompass the trailer and leave room for some other build I have in mind. According to what I am reading, a frame may be critical to support the roof and allow for ample do...

Thank you Burner Von Braun! I will keep you posted. I will need to measure the height' length and width of the Trailer to see if the Hexa Yurt roof line will be free of the trailers roof, etc... I thought about doing an autoCAD model, but that's probably overkill. I have a feeling my design will be ...

Aloha Burners!

I am interested in building a Hexayurt to fully encase my tent trailer allowing me to remove the tent from the trailer and create a lounge within a lounge with minimal set up. I am curious if anyone has tried this or if any of you have any recommendations? Thank you!