
We are using a 1600 pound generator platform as the basis for our camp setup. we will use 3/8 inch plywood for the front back and side. U-bolts to the steel uprights will hold the plywood on, and 9 inch spike will be driven thru holes in the bottom of the skirts to hold them on the ground.

the tarp canopy is 10 OZ cotton duck canvas, held tight thru grommets attached to the plywood sides. Tie downs will be sew into the tarp on the "underside" and tied to the ribs.
The red shade structure would use 2 foot long rebar driven into the ground, attached to the bottoms of the pole. At the top, the 70% red shadecloth would be attaced to a bolt (thru the grommets) with a washer and nut on top on each upright. Cables will guy the pole in two directions, staked to rebar in the ground.
Any thoughts?





