Also, why is there overlap on the top "beams" (the parts that stick out on the left and right on this pic)?
Oh, and, what is the top cover in this pic? Canvas? Wood?


lazyvegan wrote:my first year i built such a structure. it held up great, but the next year i dumped the wood for conduit. now it all goes together in no time. i'd recommend 1" conduit which can be re-used every year. and no digging is required either.
connect it all together with connectors like these-> http://www.shelters-to-go.com/low1galvanized.shtml ...i'd recommend the low-peak ones, and buy a 'good' tarp and bungee balls to make it taut/quiet. i use a 20x16' tarp, and cut the conduit to size. add some feet connectors too if you want. i normally run some rope/rebar as guylines to make sure i don't fly away to oz.
it has never failed me in 5 five years of luxurious desert living, and it really doen't get any simpler. and it's nice to get quick superquick shade in the blazing sun in no time. leaves me more time for building other stuff and drinking/whoring. peace....
Nightterror wrote:I secure my conduit structure with 1/2" x 6' rebar. First I measure out a 10 x 10 square and in each corner I drive the rebar 18" into the Playa. Then I slide the conduit over the top of the rebar. No tie downs. The custom fit cover helps keep it tight. I figure if it can stand up to 2004's beating it can stand anything.
The overlap is so that little diagonal supports could be added to reduce the tendency of right-angle structures to collapse. Adding diagonals to any structure like this is highly reccomended. It doesn't have to be lumber necessarily- could be wire guylines, although they're a hazard unless marked. Little triangular corner braces cut from plywood work well too, and show up often in DPW architecture so I'd say they're effective.DallasPlaya wrote:Also, why is there overlap on the top "beams" (the parts that stick out on the left and right on this pic)?
nocternal_steve wrote:I had something similar and the area shaded will not be very large, the sun is (almost) never directly overhead, you will find that during the afternoon
especially more than half the area under the roof will be exposed to direct
sunlight . Putting shadecloth around the sides will help.
robotland wrote:The overlap is so that little diagonal supports could be added to reduce the tendency of right-angle structures to collapse. Adding diagonals to any structure like this is highly reccomended. It doesn't have to be lumber necessarily- could be wire guylines, although they're a hazard unless marked. Little triangular corner braces cut from plywood work well too, and show up often in DPW architecture so I'd say they're effective.DallasPlaya wrote:Also, why is there overlap on the top "beams" (the parts that stick out on the left and right on this pic)?
) and need to set up a shade structure for it. We were discussing technical solutions on our forum, and I am delighted to see that, as usual, "the Playa provides". Advise and expertise in this case.